OKI PM4410 Manual de usuario descargar pdf (Pagina 23)

E-21Pacemark 4410 Setup Guide

Load Paper

Front Feed Continuous Forms

Paper Specifications: Front Feed

Maximum thickness: 0.031 inches (0.79 mm)

Type Weight Width

Single Part 12 to 24 lb. (45 to 90 g/m

) 3* to 16.5 inches (76 to 419 mm)

Carbonless 9 to 11 lb. (34 to 41 g/m

) 3* to 16.5 inches (76 to 419 mm)

(1 + 9 max.)

Interleaf 9 to 14 lb. (34 to 52.5 g/m

) 3* to 16.5 inches (76 to 419 mm)

(1 + 6 max) 9 lb. (34 g/m

) carbon

Labels 0.011 inch (0.28 mm) thick 3¼ to 15 inches (83 to 381 mm)

Envelopes 24 lb. (90 g/m

) max. 3 to 10 inches (76 to 254 mm)

Card Stock 100 lb. (375 g/m

) max. 3 to 8 inches (76 to 203 mm)

* For paper widths less than 5 inches (127 mm), remove the support between the

tractors.

When using paper which is thicker than 7-part carbonless or

its equivalent, you must enter the Menu mode, then go to the

Impact Mode item in the Set-Up group and select High

Impact Copy as the setting.

To load front-feed continuous forms:

Preparation

1. Position the printer at the front edge of the support (this promotes the

unrestricted flow of paper into the printer), then place a stack of

continuous forms below the printer. Recommended height of printer

support, 29.5 inches (750 mm).

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 71 72

Sin comentarios

OKI PM4410 Manual de usuario Pagina 23