OKI ML521 Manual de usuario descargar pdf (Pagina 116)

Page: 84

Service Guide ML520/521

Chapter 3 Maintenance & Disassembly

3.2.15 Guide Rail and Adjust Cam

1. Perform these procedures:

3.2.01

, 3.2.02 , 3.2.04 , 3.2.10 , 3.2.11 , and 3.2.14 .

2. Rotate the adjust cam (1) in the direction of arrow A as far as possible.

3. Pull the cam out and remove it.

4. Carefully press the claw (2

location only

) in the base frame down to release the guide rail (3). Do not

press too hard or the claw will break.

5. Use a straight slot screwdriver to slide the guide rail in direction of arrow A.

6. Lift the guide at position B and work the other end of the guide free to remove the guide rail.

7. Remove the ground clip (4)

NOTE:

Installation

After installing the guide rail, check the printhead gap adjustment. Refer to Section

3.3 of this Service Handbook.

P/N 51009701 Guide: Rail Ground Clip RSPL Both B.2.04

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 268 269

Sin comentarios

OKI ML521 Manual de usuario Pagina 116